Canon Cleaner for 5D, 10D, 20D, 30D, 300D and 350D

Due to Canon's random below standard low pass dichroic filter coatings Dust-Aid is now providing Canon Cleaner tapes. The Canon Cleaner tapes are applied to the base of Dust-Aid's current low tack foam tapes so you can clean the sensor filter as usual. The Canon Cleaner adhesion level to steel is about 1/4th that of Dust-Aid's low tack foam tape. These tapes will greatly reduce the chance of removing Canon's random weak coatings.

If you have already used Dust-Aid foam tapes on your Canon and are the proud owner of a standard coated sensor filter then you can continue to use Dust-Aid without the Canon Cleaner.

The Canon Cleaner tapes are for Canon camera models 5D, 10D, 20D, 30D, 300D and 350D. Below are the instructions on how to apply the Canon Cleaner to your Dust-Aid foam tapes.

Step 1 Remove white tab from Dust-Aid foam.	Step 2 Apply wand to the top of the Dust-Aid Foam.	Step 3 Expose Canon Cleaner from its bag.
Step 4 Place wand with DA foam onto one Canon Cleaner. Make sure that the Canon Cleaner tape can be seen on all sides of the DA foam.	Step 5 Lean wand and remove Canon Cleaner from liner, you're ready to clean.	Step 6 Clean sensor filter as usual. Discard foam and Canon Cleaner after use.

If your Dust-Aid tin did not come with a Canon Cleaner and you have not used Dust-Aid yet on your Canon, please contact us and we will mail one out to you. Please e-mail us your contact information, your Dust-Aid UPC number on the back of the tin and your camera's model and serial number to service@Dust-Aid.com and we will mail you a Canon Cleaner.

Please contact us at service@Dust-Aid.com with any questions.

The Dust-Aid Team